EasyManua.ls Logo

Emos 98105 - GB Wireless Doorchime; Technical Specification; Getting Started

Emos 98105
32 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
S2
CR2032
GB | Wireless Doorchime
The wireless digital doorchime set consists of the
bell pushbutton (TX) and the bell unit (RX). The
bell unit should be placed indoor or it can be used
as a portable pager. The transmission between
the pushbutton and the bell unit is based on radio
waves on frequency 433.92 MHz. Transmission
range is up to 100 m in open area, depending on
the conditions.
Please read the following user manual carefully.
Technical specication
Transmission range: up to 100 m in open area
Pairing method: self-learning function
Possibility to pair more pushbuttons: yes (max 8)
Number of melodies: 16
Adjustable volume: 3 levels
Three dierent operating modes: only ringing;
only light signaling; both ringing and optical
signaling
Waterproof pushbutton: with IP44 coverage
Operating frequency: 433.92 MHz,
10mWe.r.p.max.
Power of pushbutton: 1× 3 V (CR2032)
Power of bell unit: 3×1.5 V batteries (type AA)
Getting started
1. Remove the casing of the battery compart-
ment at the back of the bell unit. Insert
3 pieces of 1.5 V batteries, type AA, according
to the polarity indicated at the bottom of the
battery compartment. Put the battery com-
partment casing back. Do not combine new
and old batteries or dierent types of batteries
(alkali, carbon-zinc and nickel-cadmium), do
not use rechargeable batteries!
2. Remove the back casing of the pushbutton
through the hole in the side of the casing with
a screwdriver. Insert 1 pc of 3 V battery, type
CR2032 according to the polarity indicated.
Reassemble the pushbutton casing.
3. Press the pushbutton of the bell (transmitter)
to sound the bell. A red LED diode will indicate
that radio signal was transmitted and that the
pushbutton is matched with the bell.
4. To match other pushbuttons, repeat the
procedure according to point 3.
5. Pushbuttons can be matched within 25 sec-
onds after inserting the battery.
6. If you want to match other pushbuttons later,
proceed according to point 1, 2, 3.
7. You can match a maximum of 8 buttons
this way.
8. The broadcast range is 100 m in free space
and without electromagnetic interference.
This range may be aected by local condi-
tions, e.g. the number of walls the signal
passes through, metal doorframes and other
elements, which aect the radio signal trans-

Related product manuals