EasyManua.ls Logo

Emos E0086 - Installation

Emos E0086
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
Installation
Recharging the Battery
Connect the radio via cable to a USB port or charging adapter (not included).
Recharge time is approximately 2 hours. While the battery is charging, a
charging indicator will be ashing on the screen. Do not use a charging
adapter to charge the battery for longer than 24 hours.
Warning
If you have not been using the device for a longer period of time, the
rechargeable battery might be fully drained and may be in „sleep mode“.
This is typical for all rechargeable batteries. When rst recharging the
battery, we recommend charging for at least 5, but no more than 24 hours.
Radio Controls
Pressing and holding the ON/OFF button (13) for 3 seconds turns on the
radio. Select the FM radio band by pressing the MODE button (6) one or
more times. The screen shows the frequency of the radio station. To select
a radio station, use the – (2) or + (3) tuning buttons. Set volume using the
Vol– (11) and Vol+ (8) buttons. Press and hold the ON/OFF button (13) for
3 seconds to turn the radio o.
Using Headphones
Headphones (not included) can be connected via a 3.5 mm connector (16);
the speaker will be disconnected. Avoid using the headphones at high volume
to prevent damaging your hearing.
Tuning Radio Stations
Manual Tuning
To manually tune a frequency of choice, press the 10– (2) or 10+ (3) tuning
button one or more times until you reach the correct frequency.
Automatic Tuning
To initiate automatic search for functions, press and hold the 10– (2) or 10+
(3) tuning button. The search will stop once a station is found.
Saving Station Presets
You can save up to 50 radio stations into the radio‘s memory. A saved preset
can be erased from memory by overwriting it with a dierent frequency.
Automatic Preset Saving
To automatically nd and save found stations under presets, press and
hold the PROG button (5). The receiver will tune all available stations and
save them under presets P01–P50. To switch between saved presets, use
the Previous (12) and Next (10) buttons. You cannot change the order of
automatically saved presets.
Manual Preset Saving
Tune in to the station of choice (see radio station tuning).
Short-press the PROG button (5) to enter programming mode.

Related product manuals