Emos H8010 - Page 4

4
2. Changing Programming (Default) Code
– Enter programming mode (12341234 by default); an orange diode will light up.
– Press * and 3 (the orange diode will begin ashing).
– Enter a four-digit code and conrm by entering it again. If the change is successful,
you will hear a long beep. Otherwise, a double beep will sound.
– Press the hash (#) key to exit programming mode or wait for ca 30 s.
3. Selecting Keypad/Reader Mode
(Model DH16A–10T (H8010) functions only as a keypad. Reader function is not
implemented.)
– Enter programming mode; an orange diode will light up.
– Press * and 0; the orange diode will begin ashing.
– Enter 00 – functions only as RFID reader.
– Enter 01 – functions as RFID reader and keypad.
– Enter 02 – functions only as keypad.
– Successful setting is conrmed by a long beep, unsuccessful by a double beep.
– Press the hash (#) key to exit programming mode or wait for ca 30 s.
4. Activation and Deactivation of Doorbell Function (Only for Relay 2)
– Enter programming mode; an orange diode will light up.
– Press * and 2; the orange diode will begin ashing.
– Enter 01 – doorbell is inactive.
– Enter 02 – doorbell is active.
– Successful setting is conrmed by a long beep, unsuccessful by a double beep.
– Press the hash (#) key to exit programming mode or wait for ca 30 s.
* Entry codes for zone 2 are not functional when the doorbell function is
active.
* Pressing the asterisk key activates the doorbell circuit.
5. Alarm Activation/Deactivation
– Enter programming mode; an orange diode will light up.
– Press * and 6; the orange diode will begin ashing.
– Enter 01 – alarm o.
– Enter 02 – alarm on.
– Successful setting is conrmed by a long beep, unsuccessful by a double beep.
– Press the hash (#) key to exit programming mode or wait for ca 30 s.
* Keypad alarm activates upon attempted removal of the keypad.
6. Setting Code for Zone 1 (Relay 1)
– Enter programming mode; an orange diode will light up.
– Enter code position between 000–999 (e.g. 001, 002, …, 999).
– If a red LED lights up, an entry code is already stored in that position. You can delete
it by double pressing the asterisk key. Successful deletion is indicated by a long beep.
– If a green LED lights up, the position is vacant.
– Enter a four-digit code or use an RFID fob, card or sticker. Successful entry is
conrmed by a long beep.
– Press the hash (#) key to exit programming mode or wait for ca 30 s.