EasyManua.ls Logo

Emos P5613 - Page 12

Emos P5613
132 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12
By the thumb-wheel select the (dL) icon and press the thumb-wheel.
By the thumb-wheel set on/o.
By the thumb-wheel you can switch over between heating/cooling modes or both (we recommend to set the same
way for both modes).
Conrm by pressing OK and hence you will again access the preset mode.
To return to menu press OK again.
Thermostat’s Surrounding Temperature Calibration (TP)
The thermometer has been calibrated during its production process, however, to optimize it, it is possible to perform
the calibration e. g. according to some reference thermometer.
It is possible to do the thermostat’s temperature calibration in the range of -2.5 (L) to +2.5°C (H).
By the thumb-wheel select the (TP) symbol and press the thumb-wheel.
By the thumb-wheel set the required current surrounding temperature which will be shown in the right part ofthe
display.
Low Batteries
When the batteries are low in the thermostat, the following symbols starts ashing on the display
.
Change the batteries.
ATTENTION: The content of this instruction manual may be changed without a prior notice – due to the limited
printing options, the displayed symbols may slightly dier from the illustrations on the display. The content
ofthis instruction manual cannot be multiplied without a prior producer’s consent.
The company Emos spol.s r.o. declares that the T13RF + receiver has been issued a declaration of conformity
with the basic requirements and further relevant provisions of the 1999/5/ES standard. This device may
be freely used within the EU countries. The declaration of conformity is the part of the instruction manual,
otherwise it is possible to nd this on the following web pages: http://shop.emos.cz/download-centrum.
BEZDRÁTOVÝ TERMOSTAT – T13RF
Termostat T13RF je určen k ovládání topných nebo klimatizačních systémů. Na rozdíl od běžných domácích termostatů,
má termostatický systém T13RF oddělenou a bezdrátově propojenou ovládací jednotku (vysílač) a spínací jednotku
(přijímač). Spínací jednotka slouží k připojení a spínání topných/klimatizačních systémů a přenosná ovládací jednotka
slouží k obsluze a nastavování teplot. Jednotky mezi sebou komunikují pomocí rádiového signálu. Výhodou systému
je variabilnost a snadnější dostupnost regulace teploty.
CZ

Related product manuals