3
GB | Wireless Doorchime
The set consists of a doorbell button (transmitter) and a chime (receiver). The
doorbell is powered by 3× 1.5 V AAA batteries. The transmission between the
button and the chime is done via radio waves at a frequency of 433.92 MHz.
The range depends on local conditions and reaches up to 180 m in open spaces
without interference.
The set has a so-called "self-learning" function – the button is able to generate
its own pairing code which is then received by the chime and stored in its mem-
ory. The set can thus be expanded with additional buttons. Their "self-learning"
function also prevents them from aecting neighbouring doorbells.
For proper usage of the wireless doorbell, read the instruction manual
thoroughly.
Specications
Transmission range: up to 180 m in an open area (can drop down to one fth
in a busy area)
Transmission frequency: 433.92 MHz, 5 mW e.r.p. max.
Button: water resistant; enclosure rating IP56
Pairing of chime with buttons: self-learning function
Pairing capacity: maximum of 6 buttons (replacement button P5728T)
Number of ringtones: 52
Chime power supply: 3× 1.5 V batteries (type AAA)
Button power supply: 1× 12 V battery (type A23)
Includes: double-sided adhesive tape
Chime Description (see Fig. 1)
1 – bell LED
2 – battery compartment
3 – holes for hanging
4 – speaker
5 – ringtone change button
6 – pairing/volume setting button
Button Description (see Fig. 2)
1 – ring button
2 – button LED
3 – hole for opening the battery
cover
4 – battery compartment
Button Installation (see Fig. 3)
Pairing the Button with the Chime
1. Remove the rear cover of the button by inserting a screwdriver into the
hole on the bottom side. Insert a 12 V battery, type A23, into the button.
When inserting a battery, make sure to observe the correct polarity!
2. Insert 3× 1.5 V AAA batteries into the chime. When inserting the batteries,
make sure to observe the correct polarity.
Use alkaline batteries only; do not use re-chargeable batteries.
To Next Page
Loading...
