13
7. Quickly deleting data
7.1. Press and hold „ENERGY/+“ and „COST/-“ simultaneously for 3 seconds, until
the screen starts blinking.
7.2. Then press and hold „SET/OK“ for 3 seconds. All the data will be erased.
8. Replacing batteries
8.1. Open the battery compartment cover on the back side of the consumption
metre.
8.2. Remove the at batteries.
8.3. Insert new 2× 1.5 V (LR44/AG13) batteries. Make sure you observe the correct
polarity. Use alkaline batteries only, not rechargeable ones.
8.4. Close the cover.
Safety warning
• Connect the metre to a230 V~/50 Hz (±10 %), max. 16 A network tted with
asafety switch/contact.
• Only appliances powered by 230 V~/50 Hz voltage can be connected to the metre.
• Pay attention to the data on the type label of the appliances connected to the
device.
• T he maximum input power of the connected appliances must not exceed 3 680
W (max. current 16 A).
• Use the metre in closed spaces and dry environments only. Using the metre
outdoors is strictly forbidden!
• The screen is powered using alkaline batteries. Do not recharge, short circuit
or destroy the batteries or throw them in are. Do not combine new and old
batteries, dierent types, systems or brands. Remove the batteries if the device is
not used for alonger period of time. Store the batteries out of range of children.
• Any use of the device which is not listed in the previous sections of this manual
will lead to damaging the product and can create arisk of short circuiting, injury
by electric current etc. The metre must not be altered or otherwise restructured!
Safety warnings must be followed unconditionally.
• We take no responsibility for material damage and injury to persons caused by
P5801
To Next Page
Loading...
