3
P5801
Display settings:
1. current time setup
1.1 Press and hold the „SET/OK“ button for 3 seconds. You will enter the settings
mode and the clock icon will start blinking.You can change the time values using
the buttons „ENERGY/+“ (increasing values) or „COST/-“ (decreasing values). Pressing
the „HISTORY“ button will switch between hours and minutes. Once current time is
set, press „SET/OK“.
Switching to 12/24 hour mode
After setting the current time, the metre will work on a 24 hour time cycle. If
you want to switch to 12 hour mode, simultaneously hold the „HISTORY“ and
„ENERGY/+“ buttons for 3 seconds. The display will show the AM or PM symbol. AM
indicates morning hours, PM afternoon hours. Set the desired time mode (12/24).
1.2 Total operating time of the connected appliance (TOTAL TIME):
Once the load (input power of the connected appliance) exceeds 2 W, total time will
start recording automatically. You can display the total operating time by pressing
the „COST/-“ button.
To Next Page
Loading...
