Emos profi E6016 - Page 7

7
You can postpone (snooze) the alarm by 5 minutes by pressing the
button. After pressing, the
icons will start ashing.
Turn o the alarm by pressing
. After pressing, the icons will stop ashing and
only
will remain on the screen. The alarm will activate again the next day.
Setting Altitude and Atmospheric Pressure
The station shows atmospheric pressure in hPa or inHg and keeps a history of pressure readings for
the last 12 hours.
To achieve more accurate calculation of pressure values, it is advised to manually set the altitude for the
place where the weather station is being used.
1. Short-press the
button three times
2. Press the button for 3 seconds and use the arrows to set altitude between -90 m to +1,990 m
(10 m increments).
3. Pressing the button switches between M/hpa and Ft/inHg units.
4. Short-press the button to quit settings.
Setting Unit of Precipitation
1. Press the button ve times, then press the button for 3 seconds.
2. Use the
and arrows to set mm or inches as units.
3. Short-press the button to quit settings.
Setting Unit of Wind Speed
1. Press the button six times, then press the button for 3 seconds.
2. Use the
and arrows to set km/h or mph as units.
3. Short-press the
button to quit settings.
Setting Temperature Limits for Maximum and Minimum Temperature
Temperature limits can be set independently for up to 3 outdoor temperature sensors.
When minimum or maximum temperature limit is activated, the
(min) or (max) icon will
appear on the screen and disappear after deactivation.
Temperature limit ranges
Outdoor Indoor
Minimum -30°C to +10°C 0°C to 23°C
Maximum 28°C to +60°C 26°C to 50°C
Resolution 0.5°C 0.5°C
While on the main screen, repeatedly press the
button to switch to sensor 1, 2 or 3 and proceed
for each sensor as follows.
1. Short-press the button four times.
2. Press the button for 3 seconds and set the minimum outdoor temperature.
3. Short-press the button and activate (ON)/deactivate (OFF) the outdoor minimum temperature
alert.
4. Short-press the button and set the minimum outdoor temperature.
5. Short-press the button and activate (ON)/deactivate (OFF) the outdoor maximum temperature
alert.
6. Short-press the button and set the minimum indoor temperature.
7. Short-press the button and activate (ON)/deactivate (OFF) the indoor minimum temperature
alert.
8. Short-press the button and set the minimum indoor temperature.
9. Short-press the button and activate (ON)/deactivate (OFF) the indoor maximum temperature
alert.
When the set temperature limit is exceeded, an audio alarm will sound for 1 minute and the value will
begin ashing.