To Next PageTo Next Page
Need help?Do you have a question about the Empire Comfort Systems VFSR-16-3 and is the answer not in the manual?
General| Model | VFSR-16-3 |
|---|---|
| Category | Gas Heater |
| Fuel Type | Natural Gas or Propane |
| Venting | Vent-Free |
| Venting Type | Vent-Free |
| BTU Input | 16, 000 BTU/h |
| Ignition System | Piezo |
| BTU | 16, 000 BTU/h |
| Efficiency | 99.9% |
Critical safety procedure for detecting gas leaks by recognizing the odorant.
Explains odor fade and its implications for leak detection sensitivity.
Key considerations for safe handling and operation with LP gas.
Guidance for installers on interacting with the owner and the appliance.
Notes on specific installation scenarios and gas types.
Lists available optional accessories for the appliance.
Steps to take before beginning the installation process, including package inspection.
Defines who is qualified to perform installation and servicing.
Covers specific state requirements and altitude considerations.
Explains water vapor production and mitigation for unvented heaters.
Specifies required distances to combustible materials for safe installation.
Requirements for preparing factory-built fireplaces for installation.
Requirements for preparing masonry fireplaces for installation.
Instructions for installing a damper clamp for vented configurations.
Step-by-step guide for assembling and securing the gas log unit.
Table detailing gas pipe diameters based on length and gas type.
Guidance on installing gas cocks and performing pressure tests.
Instructions for decorative placement of lava rocks on the fireplace floor.
Describes expected flame appearance and initial break-in period.
Critical safety warnings and procedures before attempting to light the pilot.
Step-by-step guide for lighting the pilot and main burner.
Critical safety warnings and procedures before attempting to light the pilot.
Step-by-step guide for lighting the pilot and main burner.
Critical safety warnings and procedures before attempting to light the pilot.
Step-by-step guide for lighting the pilot and main burner.
Visual guide to correct and incorrect pilot flame patterns.
Instructions for cleaning the pilot assembly and ODS.
Recommendations for professional annual servicing to prevent issues.
Routine maintenance tasks for logs, burners, and air intakes.
Explanation of millivolt system operation and optional controls.
Wiring details and diagram for VFSR models with remote options.
Wiring details and diagram for VFSV models with remote options.
Addresses problems with spark, pilot ignition, and pilot outage.
Covers shutdown, odors, noises, gas leaks, and low pressure.
Addresses issues like roaring flames, smoking, whistling, and no pilot.
Procedures for ordering parts after the warranty period.
Process for obtaining parts under warranty, requiring proof of purchase.
