EasyManua.ls Logo

Empisal EIP003 - Maintenance and Storage; Auto Shut-Off Function; Cleaning the Steam Press; Proper Storage

Empisal EIP003
13 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
CARE AND STORAGE GUIDELINES
AUTO SHUT-OFF
The Auto Shut-off feature of the Digital Fabric Steam Press includes both an Auto
Shut-off and an Auto Wake-up. These multiple function safety features deactivate
electrical power to the heater when the Pressing Plate has been left in closed position
against the Ironing Board for more than 10 seconds. Heater functionality is restored
when the Pressing Plate is lifted back up.
Power to the heater will also be cut if the Pressing Plate is left in the lifted position
without use for approximately 15 minutes (signaled by a beeping sound for
approximately 22 seconds).After the beeping sound has stopped, the heating ability of
the unit can only be restored by pressing the Temperature Control Buttons.
IMPORTANT: Auto shut-off does not mean that power to the unit is totally cut
off. Power is always on, and the power indicator light will remain illuminated
until On / Off switch is set to Off position.
CLEANING THE DIGITAL FABRIC STEAM PRESS
1. Fill water reservoir with water using procedure on page 7of this manual.
2. Place Pressing Cushion in the middle of Ironing Board.
3. Place a clean towel over Pressing Cushion and Ironing Board.
4. Set Temperature Control Buttons to the highest setting (linen).
5. When Steam Burst Ready Indicator Light illuminates, lower Pressing Plate onto
Pressing Cushion.
6. Press Steam Burst Button six times.
7. Allow Pressing Plate to cool.
8. Clean Pressing Plate with damp cloth. Do not use abrasive materials, as this may
damage Pressing Plate.
9. Ironing Board Fabric Cover is removable for cleaning. Hand wash only with
mild detergent.
PROPER STORAGE
1. Once pressing is complete, immediately turn unit off and unplug power
cord from electrical outlet.
2. Allow unit to cool completely (at least 30 minutes).
3. Lower Pressing Plate down, and turn locking knob to lock position.
4. Wrap up power cord and place in Cord Storage Compartment.
5. Store all accessories safely away, preferably near Digital Fabric Steam
Press.
6. Store Digital Fabric Steam Press in a cool, dry place.