Need help?
emporiaenergy.com/support
support@emporiaenergy.com
1-844-EMPORIA (367-6742)
Step 4(b): Prepare for
Wi-Fi connection
This step is to prepare for a wireless
internet connection. To connect to the
internet via wired LAN, see Step 4(a). Use a
screwdriver to remove a knockout from the
electrical panel. Now, feed the antenna
through the hole. Then, Screw the antenna
assembly cable to the right-hand side of the
energy monitor in the coaxial connector
marked . Finally, plug the hole with the
knockout plug. It’s acceptable to install the
antenna inside of a wall.
To Next Page
Loading...
