Empress Effects buffer - Input Adjustment (Buffer+); Boost Stomp Switch

Controls at a Glance
power: 9V DC negative
tip 2.1mm jack. 80mA or greater.
-
+
input: boost or cut the input of the
buer+ by 3dB. Use this to balance
the output of dierent guitars or to
increase/decrease the output to
the pedals in the loop.
boost stompswitch: press to
engage the boost (amout of boost
set by boost knob).
Hold for 1 second to mute the
output while tuning.
tuner: output to tuner or use as a
second output for a stereo setup, DI
for recording or for a key signal for
something that likes a clean signal
such as a gate or compressor.
pedalboard