Need help?Do you have a question about the Empress Effects buffer and is the answer not in the manual?
Explains the buffer's role in maintaining guitar signal fidelity and eliminating signal loss.
Highlights extra features in the buffer+ like selectable boost and noise filtering for enhanced control.
Details how to activate and control the clean boost feature up to 30dB using the stomp switch and knob.
Explains using the tuner out for silent tuning by muting the amp out signal with the boost stomp switch.
Describes the tuner output's use for tuning, stereo setups, DI, or clean signal routing for other pedals.
Explains the high impedance guitar input prevents loading and preserves full tone range.
Details the buffered output's capability to drive long cable runs without signal loss.
Describes the input switch for boosting or padding the signal by +/- 3dB for level matching.
Explains engaging boost and muting output for tuning by pressing or holding the stomp switch.
Details using the noise filter to reduce unwanted noise from pedals in the effects loop.
Explains controlling pickup load to affect guitar response and high-frequency content.
Describes using the buffer as a 1in 3out splitter for multiple amps or recording dry signals.
Provides a note on potential ground loops and how to lift audio ground to resolve issues.
Lists key specifications including impedance, frequency response, SNR, THD, power, and dimensions.
Details the two-year warranty, extension options, and conditions for repair or replacement.
General| Power Input Voltage | 9VDC |
|---|---|
| Enclosure Material | Aluminum |
| Weight | 0.5 lbs |
| Input Impedance | 1 Meg Ohm |
| Power Input Connector | 2.1mm center-negative barrel |
| Frequency Response | 20Hz - 20kHz |
| Dimensions | 4.5" x 2.5" x 1.5" |
To Next Page