63mm
THIS WAY
UP WHEN
WALL
MOUNTING
SIZE C
SIZE C
SIZE C
SIZE AA
SIZE AA
SIZE AA
Wireless Beacon
Installation Guide
1 Pre Installation
4 Power Device
To unlock, insert a 1.5mm
Allen key to depress the
locking clip and turn
anticlockwise to release
as shown.
Unclip the battery retaining plate from the wireless module.
When fitting / replacing batteries; observe correct polarity,
using only specified batteries.
Connect the power jumper across the PIN header.
3 Fix Mounting Plate
2 Components
Part No Product Description
device
unpowered
(pins unlinked)
device
powered
(both pins linked)
!
Installation must conform to applicable local installation
codes and
should only be installed by a fully trained
competent person.
Ensure that the device is installed as per the site survey.
The use of a non-metallic spacer should be considered if
mounting the device on to a metal surface.
Do NOT Press the Log On button on a pre-programmed
device, as this will cause communication with the Control
Panel to be lost. Should this happen, delete the device from
the system and add it back on.
Beacon Wireless Module
Mounting Plate
1
4
2
Remove the mounting plate from the wireless module by turning
it anticlockwise.
3
Battery Retaining Plate
5 Optional Device Locking
6 Configuration
To lock the Beacon into
the wireless module,
remove the cut out section
as shown.
Use both mounting holes.
Use suitable fasteners and fixings.
Once powered, reassemble the device.
When wall mounting, ensure the mounting plate is fitted in the
orientation shown.
The device’s loop address is configured within the menu structure
of the Radio Hub.
See the Specification section for compliance information.
CPR
Refer to the programming manual (Doc Ref: MK98) for full
programming information.
Free to download from
www.emsgroup.co.uk
FC-171-001
FC-171-002
FC-323-CA1
FC-323-CA2
FC-323-WA1
FC-323-WA2
White Wireless Sounder Base Only
[2]
Red Wireless Sounder Base Only
[2]
White Ceiling Beacon Only
[1]
Red Ceiling Beacon Only
[1]
White Wall Beacon Only
[1]
Red Wall Beacon Only
[1]
Example shown:
FC-323-CA1
FC-171-001
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
1
4
2
3
©2018 EMS Ltd. All rights reserved Page 1 of 2 TSD068 Iss 6 05/09/2018 AJM
Cut out section
(shaded area)
To Next Page
Need help?
General
