EMS iVCS3 - Matrix Red Pins Digital Interpretation; Matrix Red Pins Parameter Handling; Matrix Red Pins Usage Warning; Joystick Glide Modification

In the digital domain this translates as: white pins no attenuation, green pins
0.66. Red pins will allow that connection to be adjusted between the normal
signal and its inverse.
N.B. Old parameters will set automatically to a default resistors value (-1), this
parameter is saved for Snapshots but is not enabled for HVPad of the Control
Manager.
N.B. This is a setup parameter and it should not be adjusted during the
performance. If you are playing a patch and moving the resistor control at the
same time, you will encounter audio glitches.
Joystick Glide
Each new step value of JOYSTICK is low-pass filtered to move towards that
value at a rate determined by the Knob. This is the 'half-time' of the function
(in seconds), during which the curve will traverse half the distance towards
the new value, then half as much again, etc., theoretically never reaching its
asymptote.
N.B. Old parameters will set automatically to the default Glide amount, this
parameter is saved for Snapshots but is not enabled for HVPad or for the
Control Manager.
Presets
Preset Manager will collect all the Banks (i.e. .ivcs3 suffix) and Snapshots. A
Snapshot is a simple “photo” of the parameters in the UI (i.e. User Interface).
Both the Matrix and Keyboard/Sequencer are included but they can also be
excluded, see the Settings for more details.
So, once you find an interesting sound you can take a snapshot (i.e. save this
new preset) by touching the ‘plus’ icon and this new preset will be added to
the selected Bank. The top four elements of the Snapshots list are assigned
for ‘HV Snapshot Pad’, you can then sort or delete the Snapshots in the List
by tapping the ‘List Icon’. You can even share the selected Bank through
Dropbox or e-mail and you can restore the factory Built-In Banks from the
‘Cloud’ icon, there is two options:
1)
‘Overwrite’ will erase all user presets that have been saved in the factory
preset-banks and give you the unaltered factory preset-banks back;
2)
‘Merge’ will preserve the preset-banks which contain the user presets; If
you created your own user preset-banks and saved presets there they will
stay untouched.
Snapshot banks are located in Documents folder, you can access files via
iTunes Sharing (see Add files to iVCS3 through iTunes Sharing).