EMS SDROLLXL - Assembly Instructions; Step 1: Wheel and Table Leg Assembly; Step 2: Middle Board Pipe Assembly; Step 3: Middle and Mouse Board Connection

6 pages

To Next Page

To Previous Page

Assembly Instructions

Step 1: Screw the Wheels (H) into the Table Leg

(1) using the Wrench (J). Connect the Table Leg

(1) and the Middle Bar (2) with four M6x45

Flat-End Screws (E).

Step 2: Unscrew the rotating handles of the Q-

Shaped Clamps (G) and place them over the

Circular Pipe (5). Then connect the Circular Pipe

(5) with the L-Shaped Pipe for Middle Board (3)

using two M6x45 Flat-End Screws (E).

Step 3: Connect the Q-Shaped Clamps (G) with

the Middle Board (8) and the Mouse Board (9)

using eight M6x12 Flat End Screws (B).

*Do not tighten screws until assembly is complete*