EMS SDROLLXL User Manual

Introduction
Thank you for purchasing the MIND READER™ XL Rolling Standing Desk.
These Assembly Instructions are intended to provide you with guidelines
to ensure that assembly and operation of this product is safe and does
not pose risk to the user.
Please read all directions before using the product and retain this guide
for reference. This product is intended for household use only. It is not
intended for commercial use.
Safety Precautions
▪ WARNING: CHOKING HAZARD- Small
parts. Not for children under 3 years.
▪ Keep all small parts away from children
while you assemble the product, as
these parts could present a choking
hazard.
▪ Ensure all parts are present before
beginning assembly.
▪ Please make sure you have thoroughly
read and understood these
instructions, as improper assembly
could lead to personal injury or
property damage.
▪ Do not attempt to modify the product
from the instillation instructions.
▪ Make sure to set up the product on a
stable, solid surface.
▪ Make sure that you install all parts as
described. Any variation or
modification of parts could be
detrimental to the performance of this
product.
▪ Do not allow children to assemble or
play on this device.
▪ Do not place this XL Rolling Standing
Desk outdoors or in other damp
environments, as this could cause
corrosion of the metal and mildew on
wood surfaces.
▪ Do not sit, jump, or step on this
product.
▪ Do not tighten screws until assembly is
complete.
© 2021. EMS Mind Reader, LLC. All Rights Reserved.
1
XL Rolling Standing Desk
Assembly Guide
SDROLLXL

EMS SDROLLXL Specifications

Weight and Dimensions

length	38.19” (97 cm)
width	23.62” (59.99 cm)
height	26.77” (67.99 cm)
weight	29.04 lb.

Summary

Introduction and Safety Precautions

General Safety Guidelines

Includes warnings for child safety, correct assembly, product integrity, and safe usage environments.

Package Contents Overview

Assembly Instructions

Step 1: Wheel and Table Leg Assembly

Connect wheels to table legs and attach the middle bar using M6x45 flat-end screws.

Step 2: Middle Board Pipe Assembly

Assemble circular pipe with L-shaped pipes and clamps for the middle board using M6x45 screws.

Step 3: Middle and Mouse Board Connection

Connect middle and mouse boards using Q-shaped clamps and M6x12 flat-end screws.

Step 4: Upper Board and Square Pipe Attachment

Attach L-shaped pipe for upper board to upper board and square pipe using M6x20 and M6x45 screws.

Step 5: Integrating Sub-Assemblies

Insert assembled parts from previous steps into the table leg and secure with rotating handles.

Step 6: Pen Holder and Barrier Strip Installation

Place pen holder strip on upper board and attach barrier strip to middle board with M6x20 screws.

Step 7: U-Shaped Pipe and Lower Board Assembly

Screw wheels into U-shaped pipe and attach to lower board using M5x50 pointed-end screws.

Step 8: Final Table Leg and Lower Board Connection

Connect table leg to lower board using M5x60 pointed-end screws to ensure stability.

Care, Maintenance, and Specifications

Product Care and Maintenance

Instructions on stopping use if broken, checking screw tightness, cleaning methods, and avoiding chemical solvents.

Product Specifications

Details on the desk's dimensions (length, width, height) and weight.