EMX Industries, Inc. IRB-MON

Questions and Answers

J
Joel BuckJul 27, 2025
Why is the green LED flashing on my EMX Industries, Inc. Lighting Equipment when there is no obstruction?
- T
  tracigriffinJul 27, 2025
  If the green LED on your EMX Industries, Inc. Lighting Equipment flashes continuously even when there is no obstruction, it could be due to several reasons: * The sensitivity might be too low. Try adjusting the SENSITIVITY pot clockwise. * The transmitter may not have power. Check the power source for the transmitter. * The receiver might not be able to "see" the transmitter. Ensure that the transmitter and receiver have a clear line of sight alignment.
K
Kimberly ChristianAug 3, 2025
How to fix EMX Industries, Inc. Lighting Equipment when it does not detect obstruction of beam?
- A
  Ashley StevensAug 3, 2025
  If your EMX Industries, Inc. Lighting Equipment is not detecting obstructions, it might be because: * The sensitivity is set too high. Try adjusting the SENSITIVITY pot counter-clockwise. * The signal is reflecting off another surface. Inspect the area for highly reflective surfaces that might be interfering with the beam.
D
David RossAug 11, 2025
What to do if the receiver of EMX Industries, Inc. Lighting Equipment activates but does not transmit signal to operator?
- J
  Janet BurkeAug 11, 2025
  If the receiver on your EMX Industries, Inc. Lighting Equipment activates but doesn't transmit a signal to the operator, the issue might be a faulty connection between the receiver and the operator control input. Verify all wires and terminal connections to ensure they are properly connected.
A
Ashley JonesAug 19, 2025
Why is the receiver green LED off on my EMX Industries, Inc. Lighting Equipment?
- S
  suzannejonesSep 12, 2025
  If the green LED on the receiver of your EMX Industries, Inc. Lighting Equipment is off, it could be due to the transmitter being too close to the receiver. Try adjusting the SENSITIVITY pot counter-clockwise or increasing the distance between the transmitter and receiver.