EMX Industries IRB-MON - User Manual

EMX Industries, Inc. Tech support: 216-834-0761 1/6
IRB-MON_Rev3.0_080619 technical@emxinc.com
IRB-MON
Universal Thru Beam Photoeye
Instruction Manual
The IRB-MON thru beam infrared photoeye is an external entrapment protection device type B1,
non-contact sensor for use with automatic gates and doors. The photoeye provides a signal to the gate
or door operator that the beam is or is not obstructed. The IRB-MON operates up to 115 feet over a
wide range of voltages (6-35 VDC and 12-24 VAC). A green alignment indicator on the receiver provides
status information at a glance, making set-up and alignment easy. The IRB-MON provides compatibility
with most operators that accommodate monitored external entrapment devices per UL325.
Cautions and Warnings
This product is an accessory or part of a system. Install the IRB-MON according to
instructions from the gate or door operator manufacturer. Comply with all applicable codes
and safety regulations.
Specifications
Operating Range
Up to 115 ft (35 m)
Power
6-35 VDC, 12-24 VAC
ononly)
Current (NC and 10K Monitoring Methods)
60 mA (relay activated)
Current (Pulse Monitoring Methods)
15 mA
Surge Protection
Thermal fuse
Relay Output Operation
Light ON/Dark ON
Relay Output Configuration
Form C contacts (NO, COM, NC)
Transmitter Power Cycle
<300 mS (for use in NC or 10K monitoring)
Operating Temperature
-40° to 170°F (-40° to 77°C)
Dimensions (L x W x H)
2.3” (57 mm) x 2.6” (65 mm) x 3.7” (94 mm)
Environmental Rating
NEMA 4X
TM

Summary

Safety Cautions and Warnings

Product Specifications

Ordering Information

Monitoring Methods Explanation

IRB-MON Board Diagram

Installation Guide

LED Indicators

Summary of LED status lights on the receiver for alignment and operation.

Configuration Settings and Wiring

Troubleshooting Guide

Product Warranty Information

EMX Industries IRB-MON Specifications

General

Brand	EMX Industries
Model	IRB-MON
Category	Accessories
Language	English