EL – Battery Limits – Rev.01 – September 2022 III
PREFACE
Thank you for choosing Enapter. Please study these battery limits carefully before unpacking, installing,
and operating the device.
If you have any further questions, please contact the Enapter customer support team. Quote the device
serial number and hardware number on the back of the device to help identifying your product quickly.
ENAPTER SRL
Headquarter: Via di Lavoria 56/G
56040 Crespina (PI) – Italy
T.: +39 050 644 281
E.: support@enapter.com
Website: www.enapter.com
VAT no. 13404981006
SCOPE OF THE DOCUMENT
This document must be read and understood in addition to the owner’s manual which is also available
on handbook.enapter.com. Reading this document does not replace the intensive studying of the
owner’s manual.
The purpose of this document is to define and describe the battery limits of the Electrolyser 4.0. It
illustrates the physical interface ports of the device, to allow the operator to integrate it with the other
equipment that composes his system.
This document applies to all Enapter devices with the following product code: ELE4005XXXXXSV00
APPROVED USE
This device must only be operated for its intended purpose, according to the specifications and
instructions provided in the owner’s manual. This document is intended as ancillary information only.
Keep this document in a safe place and readily available. It is the operator’s responsibility to ensure
that an installed device is always in proper conditions. Please observe any additional local requirements
applicable to the installation and operation of the device.
Improper use of the device can result in serious injuries and damage to the
environment.
Always use the device according to the specifications described in this document.
Ensure that this document is always accessible.
Make sure you have read and understood this document in its entirety.
Comply with all safety instructions and warnings.
To Next Page
Loading...
