GBS
INSTALLATION INSTRUCTIONS
PRODUCT SAFETY
When using electrical equipment, basic safety precautions should always be followed, including the following:
Do not let power supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Equipment should be mounted in locations and at
heights where it will not readily be subjected to
tampering by unauthorized personnel.
The use of accessory equipment is not
recommended by Encelium as it may cause an
unsafe condition.
Do not use this equipment for other than the
intended use.
SAVE THESE INSTRUCTIONS.
READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT.
GETTING STARTED
Overview
The GreenBus Sensor(GBS) family of ceiling/surface mount sensors provides a range of networked sensor solutions for applica-
tions with finished ceilings (e.g. ceiling tiles, sheetrock, plaster). They combine passive infrared (PIR) and photocell sensing in a
single compact form factor.
The GBS is available in three models:
• Standard Range
• Extended Range
• High-Bay
To Next Page
Need help?
General
