Enclume DR5 Retro Rectangle Rack
Enclume Décor racks are the ultimate in
quality, design, strength and function.
Congratulations for owning one of the finest
storage racks made.
WARNING:
READ ALL OF THE INSTRUCTIONS
BEFORE ASSEMBLING AND USING
YOUR RACK.
Enclosed you will find everything needed for the assembly
and use of your pot rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
2 – Ceiling Hooks - large
2 – S Hooks - 2"
2 - 6” Chain
2 – 5/16” x 7/8” Button head Screws
4 – 5/16” x 3/8” Button Head Screws
2 – 5/16” Hex Nuts
1 - 3/16" Hex Key
Toggle Kit
Components included:
4 – 12” Upright Arms
1 – Top Bar
2 – Rack Body
4 - Grid brackets - EGB
12 - Pot hooks - EPHS
1 - Grid
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1) Lay rack body on firm surface. Protect surface with corrugated box if necessary.
2) Identify the four "Upright Arms." Using the 5/16" x 3/8" button head screws attach the upright arms to the rack body as shown.
Do not fully tighten screws at this time.
3) Locate the "Top Bar" and attach to the four "Upright Arms" as shown in drawing using the two 5/16" x 7/8" button head screws
and the two 5/16" nuts. Tighten all screws at this time.
4) Your Rack may be carefully anchored into solid wood of the ceiling joist or beams. If you are mounting in anything other than
solid wood, use the Toggles provided and follow the directions in the kit. Carefully measure the area where the rack is to be hung
and install the ceiling screw hooks (approximately 16" apart) if you are mounting in wood or the Toggles if you are mounting in
anything other than wood.
5) Place the four grid brackets over the sides of the rack, just inside each of the upright arms with the straight end of the brackets
facing towards the inside of the rack. Next place the grid on top of the grid brackets. (See note and drawing next page).
6) Insert the "S" hooks into each of the remaining holes in the top bar and the other end through one end of the chain. Carefully lift
your rack into place and attach the other end of the chain onto the ceiling screw hooks.
7) Hang your heavier item on the straight portion of the rack body or the center of the grid area.
8) All of our hammered steel racks are finished with an industrial wax designed to give years of protection to the rack. Cleaning is
easily done with a damp cloth. Dry thoroughly after cleaning. If a touch-up is ever needed we recommend a "Pledge" like wax
product
::
potracks.com
Call 1-800-667-8721 anywhere in the US and Canada - www.kitchensource.com
::potracks.com
powered by ::kitchensource.com
To Next Page
Need help?
General
