4
WARNING! Wear personal protective equipment
approved by the Canadian Standards Association
(CSA) or American National Standards Institute
(ANSI).
1. Always wear impact safety goggles that provide front and side
protecon for the eyes. Eye protecon equipment should comply
with CSA Z94.3-07 or ANSI Z87.1 standards based on the type of work
performed.
2. Wear the appropriate type of full-face shield in addion to safety
googles, as the work can create chips, abrasive or parculate maer.
3. Wear gloves that provide protecon based on the work materials or
to reduce the e
ects of tool vibraon.
3.1 Do not wear gloves when operang a tool that can snag the
material and pull the hand into the tool.
4. Wear protecve clothing designed for the work environment and
tool.
5. Non-skid footwear is recommended to maintain foong and balance
in the work environment.
6. Wear steel toe footwear or steel toe caps to prevent a foot injury
from falling objects.
7. Wear a NIOSH approved respirator when worki
ng on materials that
produce hazardous fumes, dust or parculate maer.
8. This tool can cause hearing damage. Wear hearing protecon gear
with an appropriate Noise Reducon Rang to withstand the decibel
levels.
Control the tool, personal movement and the work environment to avoid
personal injury or damage to the tool.
1. Do not operate any tool when red or under the inuence of drugs,
alcohol or medicaons.
2. Avoid wearing clothes or jewelry that can become entangled with the
moving parts of a tool. Keep long hair covered or bound.
To Next Page
Loading...