6
5. Use the tool at its correct speed and feed rate for opmal
performance and safety.
6. Never operate this tool unl it has been completely and properly
assembled and installed.
7. Always use the provided bloer and wheel anges to mount the
grinding wheels on the grinder sha to prevent wheel damage or
accidental separaon, which can result in fragments ying o the
wheel at high speeds.
8. Use only wheels suitable for t
he speed of the machine.
9. Use only wheels that have a bore exactly equal to the arbors of the
machine. Never aempt to force an undersized wheel to t an arbor.
10. Do not overghten the wheel nut.
11. Never use a tool with a cracked or worn grinding wheel. Change the
grinding wheel before using. Use only anges supplied with the
grinder.
12. Never grind a workpiece on a wheel that is cold. Run the tool for one
full m
inute before any operaon.
13. Do not grind magnesium or aluminum, as a re may result. Always
clean the wheel between operaons involving dierent materials.
14. Dress the wheel on the face only.
15. Contact a workpiece with the face of the wheel only.
16. Never apply coolant directly to the grinding wheel. Coolant can
weaken the bonding strength of the grinding wheel and cause it to
fail. Dip the workpiece in water to cool
it.
17. When operaon is complete, always disconnect the tool form its
power source and lock the switch in the o posion.
1. Do not use any power tool with a malfunconing power switch or
control. A power tool that fails to respond to the controls is
dangerous and can cause an injury. A qualied technician must repair
and verify the power tool is operang correctly, before it can be used.
2. Ensure the power supply matches the tool’s motor voltage (see
Specicaons).
To Next Page
Loading...