ENCA-CCDN
:NPENV2
All Weather CCD Security Camera with Night Vision
www.encore-usa.com
INSTALLATION PROCEDURES
Do not place the camera where there is an extreme temperature condition. Make
sure to place the camera where the temperature is within the -4°F ~ 122°F (-20℃
to 50℃) limit only.
Do not install the camera where there is a constant and severe lighting change.
Severe light with constant lighting changes can cause the camera to work
improperly causing video problems.
Do not install the camera in a very high humid place that can cover the external
lens with mist. It can cause poor quality image or alarm if sensitivity is set to a
“very high”.
Do not disassemble the camera. There are no user serviceable parts inside.
Opening the camera housing exposes you to a high and dangerous voltage and
other hazards and damage the sensitive internal components. Refer all servicing
to a qualified technician only.
Do not touch the imaging surface of the sensor. Use only proper cleaning
solutions and materials. Touching or cleaning the sensor using improper cleaning
solutions may damage the camera sensor permanently.
The package does not come with a power adapter. Make sure that the power
supply voltage is correct before operating the unit. The voltage requirement is 12
Volts DC. Check your surveillance DVR user manual power supply system.
Do not focus the camera while in operation to any extreme light, like directly to the
sun, laser light, etc.
CONNECTION DIAGRAM:
To Next Page
Loading...
Need help?
General