installed under the seat or in any open area. The unit will trigger warn away
as well as full trigger depending on the amount of time the disturbance
takes place. If the radar sensor sees movement within its range for 3
seconds, it will trigger the warn-away of the alarm with a few siren and horn
beeps. If the disturbance continues, it will trigger the primary trigger and
will sound the alarm. This sensor can be overridden by the remote in
situations where there are many motorcycles parked together. The
sensitivity of the sensor can be adjusted by turning the adjustment screw on
the sensor. Turn the adjustment screw Clockwise for more sensitivity and
counterclockwise less. The sensor will only trigger if motion is sustained for
more than 3 second. The circuit is design in this manner to minimize false
alarms and should not be used if there is always normal activity around
where the motorcycle is parked.
Main Unit: The main unit is water resistant and should be mounted in a
location that offers the best protection form the elements and is hard to get
to by a would be intruder. This can be mounted in the fairing, side cover,
under the tank or the tail of the motorcycle or ATV. It should be securely
mounted with screws if at all possible. The main unit does come with high
strength Velcro included but securing this unit will provide better results.
The impact 3 axis sensor is located in the main unit and will sense impact
better if secured with screws. Please plan and choose this location
carefully.
Operation:
Button Layout:
Button 1: Arm
Button 2: Disarm
Button 3: Locate
Button 4: Microwave ON- OFF
Display:
Functions:
Arming the System:
With the ignition in the OFF position, Press button
number 1 or Lock to Arm the system. The siren
and horn will chirp once if connected and the lights
on the motorcycle will flash one time. The system
is now armed. While armed, the LED will flash two
times every 2 seconds indicating the system is
armed. The remote will show a lock symbol when the system is armed.
Disarming the System:
By pressing button 2 or disarm on the remote you
will disarm the system. The lights will flash 2 times
and the siren and horn will chirp twice. The remote
will show an unlock symbol. If the motorcycle is
disarmed and the ignition is not turned ON within 30
seconds the unit will rearm itself. To stop this
process turn the ignition switch to ON or press the disarm button twice
within 1 second. If the ignition switch is not turned ON the unit will
interpret this as an accidental disarm and will rearm the system.
Not Armed Reminder:
If the ignition switch is turned off and the unit has not been armed within 20
seconds, the unit will alert the user by chirping 3 times and flashing the
lights 3 times. It will also alert the remote and the unlock icon will flash 3
times. The unit will not automatically arm.
To Next Page
Loading...
Need help?
General
