Silent Mode:
If the Arm button or button 1 is pressed twice within 2 seconds the unit will
be in silent mode and the speaker icon on the remote will have a line
through it. In this mode the alarm will function as normal but will NOT honk
the horn or activate the siren when a trigger is recognized. When the
system is triggered by either warn-away or full trigger, the lights will flash
on the motorcycle but no audible alarm will be heard. The Remote will
make a sound and vibrate while showing what was triggered. If the warn –
away was triggered the unit will beep and vibrate showing the user what
triggered the system. If full trigger is initiated, the unit will add a melody
sound as well. All other functions of the unit will stay the same. To return
to audible mode, press the arm button again twice. This will toggle in and
out of silent mode and can be verified by the speaker icon on the remote.
Audible Mode Silent Mode
Trigger Disarm:
If the unit is triggered press the Disarm button to disarm the system or press
the arm button to stop the siren and keep the system armed.
Arming and deleting the Microwave sensor: There are times when your
motorcycle will be in an area of constant activity. This may trigger your
radar or microwave sensor. When parked in areas close to activity the
Microwave or Radar sensor can be shut off to eliminate false triggers. This
can be done by pressing button 1 to arm the system and within 2 second
pressing button 4. The remote will make a melody sound and the siren will
chirp once indicating the radar sensor will be off. The sensor will turn ON
again the next time the system is armed.
Locate:
By pressing button 3 the motorcycle will chirp the horn and siren 3 times
and will flash the lights 3 times to help you locate the motorcycle in large
parking lots.
Starter or Ignition Kill:
If installed, the unit will disable the starter or ignition when the unit has
been triggered. Warn-away and full triggers will disable this circuit. If a
starter kill was wired on the motorcycle, during trigger the motorcycle will
not start. If an Ignition disable was connected, the motorcycle will not run
during trigger events.
Emergency Disarm:
In the event that the system is armed and the remote control has been lost
or is not functioning, the unit can be manually disarmed by turning the
ignition switch ON and OFF 10 times quickly and the key left in the ON
position for 3 additional seconds. The system will not arm again until a
disarm signal is receive by the unit from any transmitter.
Out of Range Check:
Though the M1 Motorcycle alarm system has range of up to one mile, this
can vary with different environmental conditions. If the unit is out of range
for paging the remote will play a melody sound and the signal strength bar
will be at no bars.
LED Indicator:
In the armed status the LED will blink twice every 2 seconds. The LED will
flash continuously during any trigger event and if triggered will flash 4 times
every 2 seconds until the ignition is turned ON. This indicates the alarm was
triggered while armed.
Impact and Microwave sensor adjustment:
The Microwave sensor and the impact sensor both can be adjusted to
obtain the best sensitivity for the motorcycle. Caution should be used in the
setting of these devises. The more sensitivity each sensor has the more
likely it will false trigger.
Microwave or Radar sensor: This sensor is designed to help eliminate false
alarms by filtering the triggers from the sensor. The radar sensor must see
movement for 3 second before it will trigger the system. If a leaf falls from
an overhanging tree it will be ignored. The sensor can be adjusted at the
sensor with a small screwdriver. The adjustment is fairly straight forward.
Turn the adjustment counter clockwise for less sensitivity and clockwise for
greater sensitivity. The adjustment will only turn 100 degree in either
direction. Do not force the adjustment past its physical stops. The LED just
above the adjustment port will light every time the unit sees motion of any
kind. This will only light if the system is armed and the radar sensor has not
been deleted.