3 x77mm sized.5
4 digits display.
Communication via RS-485 Modbus protocol or
synchronous running between two or more potentiomers.
(Optional)
Preset value can be adjusted from external buttons.
0-10V,0-20 mA a and 4-20mA output with adjustable minimum and
maximum values.
‘Soft on’ and ‘soft off’ properties can be selected.
CE marked according to European Norms.
Easy to use by front panel keypad
Display scale can be adjusted between -1999 and 9999.
(Full scale can not be higher than a 9999)
Decimal point can be adjusted between 1. and 3. digits.
Parameter access protection on 3 levels.
.
OUTPUT
0-10V output
Digitally adjusted maximum 10mA, max. 10V potentiometer output.
Accuracy :%0.1 Resolution : 1mV
Fluctuation : Maximum 30mV
Rise time from 0 to 10V is maximum 300ms
ENDA EDP2041 DIGITAL POTENTIOMETER
Read this document carefully before using this device. The guarantee will be expired by
damages if you don't attend to the directions in the user manual. Also we don't
accept any compensations for personal injury, material damage or capital disadvantages.
Thank you for choosing ENDA EDP2041 potentiometer.
ENVIRONMENTAL CONDITIONS
Height
Max. 2000m
Ambient/storage temperature
Max. relative humidity
0 ... +50°C/-25 ... +70°C (without icing)
Rated pollution degree
TECHNICAL SPECIFICATIONS
According to EN 60529 Front panel : IP65
Rear panel : IP20
Do not use the device in locations subject to corrosive and flammable gases.
Supply
230V AC +10% -20%, 50/60Hz or 24V AC ±10% 50/60Hz or optional 9-30V DC / 7-24V AC ±10% SMPS
Power consumption
Max. 7VA
2.5mm² screw-terminal connections
Wiring
Date retention
EMC
Safety requirements
EN 61326-1: 2006 (Performance criterion B for the EMC standards)
EEPROM (Min. 10 years)
EN 61010-1: 2010 (pollution degree 2, overvoltage category II, measurement category I)
ELECTRICAL CHARACTERISTICS
HOUSING
Housing type
Suitable for flush-panel mounting according to DIN 43 700.
Dimensions
W77xH35xD71mm
Weight
Approx. 350g (after packing)
Enclosure material
Self extinguishing plastics
While cleaning the device, solvents (thinner, benzine, acid etc.) or must not be used.corrosive materials
Order Code : EDP 41-20 -
1- Supply Voltage
230VAC...230V AC
24VAC.....24V AC
SM...........9-30V DC / 7-24V
AC
2- Modbus Option
RS...... RS-485 Modbus communication
.....
With
Empty Without RS-485 Modbus communication
1
2
INPUTS
Upwards input (UP)
Contact input or max. 24VDC logic input (active low)
Downwards input (DOWN)
Contact input or max. 24VDC logic input (active low)
SET
SET
EDP2041
ENDA
DIGITAL POTENTIOMETER
TX
RX
AOUT
OUTPUT
0-20mA output
Digitally adjusted maximum 12V, max.20 mA potentiometer output.
Accuracy: %0.1 Resolution : 2 A
Fluctuation : Maximum 60 A
Rise time from 0 to 20mA is maximum 300ms
µ
µ
80% Relative humidity for temperatures up to 31 % °C, decreasing linearly to 50% at 40°C.
english
E-mail : info@suran-elektronik.de
Internet : www.suran-elektronik.de
Tel.: +49 (0)7451 / 625 617
Fax: +49 (0)7451 / 625 0650
SURAN Industrieelektronik
Dettinger Str. 9 / D-72160 Horb a.N
1. / 3 EDP2041-E-22032019
To Next Page
Need help?
General
