Commubox FXA195
4 Endress + Hauser
Ordering information
Commubox FXA195
System requirements
Hardware and software
Installation
Scope of delivery A CD-ROM with the following programs is supplied with Commubox FXA195:
• USB drivers - these are automatically installed by means of hardware detection. For an example for
installation on Windows 2000, see "Installing the USB driver" onPage 4-8.
• PreInstaller - you can use this program to install the USB drivers manually. To do so, you must first start
the program from the CD-ROM, follow the installation instructions and then connect the Commubox to
the personal computer.
• ComPortFinder - this program helps you find out which virtual COM port the USB port was set to. To do
so, simply start the program from the CD-ROM.
Installing the USB driver Note!
Please note that you require Administrator rights if installing on Windows 2000 and Windows XP!
The following are sample instructions for Windows 2000
1. Insert the "Commubox driver CD-ROM" into the CD-ROM drive of your computer.
2. Connect Commubox FXA195 to a free USB port of the computer.
The following screen tells you that new hardware has been found.
10 Approval:
G ATEX II (1)GD EEx ia IIC
P FM IS CL.I,II,III Gr.A-G
S CSA IS CL.I,II,III Gr.A-G
Y Special version
20 Additional Option:
1 Basic version
9 Special version
FXA195- Complete product designation
Hardware Minimum Endress+Hauser operating program from Version
Processor Pentium 500 MHz or higher ToF Tool - Fieldtool Package 3.01.00
Interface USB 1.1 or 2.0 FieldCare 2.01.00.383
Drives CD-ROM drive HART OPC server 2.1.1
Commuwin 2.08.01
Operating system Service Pack / extensions ReadWin 2000 1.17.2.0
Windows 2000 SP 3 or higher recommended
Windows XP SP 1a or higher recommended
L00-FXA195xx-20-13-00-en-001
To Next Page
Loading...