Endura Trilennium Replacement Instructions

FACEPLATE REPLACEMENT INSTRUCTIONS
Parts Required
• Replacement Faceplate
• Replacement Screws
Tools Required
• T-15 Torx Screwdriver
• #2 Phillips Screwdriver
Remove Old Faceplate
Open door to expose faceplate.
Using the T-15 Torx screwdriver remove the Torx drive faceplate screws.
Using the #2 Phillips screwdriver remove the installation screws securing the lock to the panel.
Remove old faceplate.
A.
B.
C.
D.
Note
If lock is installed into a hung door panel, the installation screws should never be removed without a handleset or
construction handle installed, otherwise the lock may fall out of the panel.
!
Torx
Head
Screws
* 6/8 Lock shown- longer
locks will have more screws.
Torx
Head
Screws
INTERIOR
EXTERIOR
Phillips
Head
Screws
Phillips
Head
Screws
A B, C, D

Endura Trilennium Specifications

General

Brand	Endura
Model	Trilennium
Category	Door locks
Language	English