INSTALLATION, OPERATION & MAINTENANCE
WARNING!
Manual 40100-32
12/20
Canada
1-800-461-1771
U.S.A
1-888-461-5307
GR
EA
SE
I
N
T
ERC EPT
O
R
G
REA S
E
I
N
T
ER
C
E
PTO
R
GRE
A
ROT
PECRE
T
N
I
E
S
G
R
E
A
SE I
NT
ER
C
E
PTO R
GRE A
SE IN
T
ERC E
PT
O
R
G
R
E
A
SE
I
N
TE
R
CE
PTOR
GRE
A
S
E I
N
T
ERC EP
T
O
R
G
R
E
A
SE
I
NTE
RCE
P
TO
R
*
*
*
ASME A112.14.3 (TYPE A* & TYPE C)
& CSA B481.1
PDI G-101, ASME A112.14.3 TYPE A, AND NSF ES 15741
APPLICABLE TO XL75 AND XL100 GPM MODELS ONLY
Technical Support:
tech-support@endurainterceptor.com
DO NOT PRESSURE TEST RISKOF
SERIOUS INJURY
As a plumbing appurtenance your Endura® grease
interceptor MUST be isolated from the drainage system in
the event that final drain testing or other system pressure
testing is required. DO NOT under any circumstances
subject your interceptor to pressure test (Air, Water
or Otherwise). This action will result in damage to
the unit, invalidate your warranty and could cause
serious bodily injury.
WARNING – SAFETY FIRST!
GREASE INTERCEPTORS ARE HAZARDOUS
ENVIRONMENTS AND MUST NEVER BE LEFT UNCOVERED
AND UNATTENDED, EVEN DURING MAINTENANCE.
• All access covers MUST be fully and completely secured
• All required bolts MUST at all times be in place and well tightened
• Missing bolts MUST be reported to management and replaced immediately
•
•
Covers MUST meet the required load rating for the application (see the
Technical Information section)
Do NOT use alternate covers
To Next Page
Need help?
General