EGM-PWM-LAN ENERGY METER WITH LAN INTERFACE
All brands and logos are registered trademarks of their respective owners
3.2. Power Manager installation
It is now time to identify which IP address has been obtained by
EGM-PWM-LAN. We need to carry out the following:
Insert the Power Manager CD into a PC CD-ROM drive. This PC
can be connected either to the same LAN where the device is (if you
chose option A section 3.1) or directly to the device with the
crossover RJ-45 cable (if you chose option B section 3.1)
If for any reason the automatic setup does not work, then open CD-
ROM drive in the My Computer window and launch SETUP.EXE
from the CD
Follow instructions of the installation software
NOTE: Antivirus or firewall software may block connection to
EGM-PWM-LAN. Please, configure antivirus/firewall to permit
connection to the IP address and port of your EGM-PWM-LAN
To Next Page
Loading...
Need help?
General
