Energetics CT 600 - Page 10

10
Right pedal
Please make sure pedal in your
hand is the right pedal before
Installation. Please refer to the
figure. Align the right pedal with
right crank at 90 degree. Gently
insert the pedal in the crank arm.
Turn the pedals clockwise as
tightly as you can with your hand.
Use the wrench to ensure it is
tightened securely. Please always
tighten by hand first, then finish
by wrench.
Left pedal
Please make sure pedal in your
hand is the left pedal before
Installation. Please refer to the
figure. Align the left pedal with
left crank at 90 degree. Gently
insert the pedal in the crank arm.
Turn the pedals counter- lockwise
as tightly as you can with your
hand. Use the wrench to ensure it
is tightened securely. Please
always tighten by hand first, then
finish by wrench.
Remark:
Riding this bike backwards may loosen the pedals which will damage the threads.
Please always check pedals to ensure that the pedals are tightened. If the pedals
have become loose, tighten threads with the wrench supplied to ensure they are
securely attached.