Do you have a question about the Energica EsseEsse 9 and is the answer not in the manual?
Details components (A, B, C, D) and their required torque values for installation.
Instructions for removing the right passenger footpeg and two right screws from the license plate holder.
Steps to insert two bushings into the footpeg housing and place washers on footpeg screws (B).
Fit footpeg screws with the bag holder and bushings, then screw the right footpeg without full tightening.
Screw the right side of the license plate holder loosely and remove the left passenger footpeg.
Remove two left screws from the license plate holder and insert two bushings into the footpeg housing.
Place washers on footpeg screws (B) and fit screws to match the left bag holder, bushings, and footpeg.
Screw the left footpeg and the left side of the license plate holder without fully tightening.
Fit screw (D) under the license plate holder and tighten footpeg screws (B) to specified torque.
Tighten license plate screws (C) to 10Nm and assemble four pins on the lower part of bag racks.
Tighten the four assembled pins to the specified torque of 6Nm.
| Brand | Energica |
|---|---|
| Model | EsseEsse 9 |
| Category | Motorcycle Accessories |
| Language | English |