How to troubleshoot electronic board failure in Energie Boiler?
If the electronic board in your Energie Boiler fails, it could be due to a power supply failure. Check the power supply and the corresponding circuit breaker. It may also be caused by a damaged or disconnected cable. In this case, check the integrity of the electronic board’s electric circuit.
What to do if there is water discharge on the safety group of Energie Boiler?
If you notice a water discharge on the safety group of your Energie Boiler, it may be due to the absence or incorrect sizing of expansion vessel (if the leak is not continuous). To fix this, install and/or correctly dimension the expansion vessel. If the leakage is continuous, it might be due to high pressure in the supply. Check the reducing pressure valve (if installed) or install a reducing pressure valve (if not installed).
How to fix Energie Boiler electrical heater that doesn’t work?
If your Energie Boiler's electrical heater isn’t working, it could be due to thermostat failure. In this case, check the thermostat status. Alternatively, the electrical heater itself may be damaged, so check its status as well.
Why does the fan not work in my Energie Boiler?
General| Refrigerant | R32 |
|---|---|
| Type | Split |
| Cooling Capacity | 3.2 kW |
| Heating Capacity | 3200 W |
| Power Supply | 220-240V/50Hz |
Explains danger, warning symbols, and general safety guidelines.
Details requirements for installation, weather protection, and maintenance procedures.
Presents detailed technical data for storage heater and exterior unit.
Details COP, energy efficiency, and consumption figures.
Details high/low pressure switch, safety thermostat, and PT safety valve functions.
Covers hydraulic connections, safety devices, and general setup.
Specifies minimum/maximum distances for refrigerant lines and coupling procedures.
Details water pipe connections and required safety devices.
Details the requirements and procedures for electrical connections.
To Next Page
