Energizer 395 User Manual

Chemical System: Silver Oxide (Zn/Ag
2
O)
Designation: ANSI-1162SO/1165SO, IEC-SR57
Nominal Voltage: 1.55 Volts
Typical Capacity: 52 mAh* (to 1.3 volts)
Capacity Test: 20K ohm continuous drain at 21°C
Typical Weight: 0.8 grams (0.03 oz.)
Typical Volume: 0.19 cubic centimeters (0.012 cubic inch)
Impedance (40 Hz): 5 to 15 ohms
Load
Cutoff
1.3V
(ohm) (hours)
20K 680
Typical Performance at 21°C (70°F)
mm (inches)
Typical Discharge Characteristics
at 1.55V
(milliamperes)
Schedule
Typical Drains
©Energizer Holdings, Inc. - Contents herein do not constitute a warranty.
Im
p
ortant Notic
e
This datasheet contains typical information specific to products manufactured at the time of its publication.
Continuous 0.078
Industry Standard Dimensions
ENERGIZER 395/399
Typical Performance at Low Discharge Rates
Temperature Characteristics
SILVER OXIDE
Specifications
Cross Section
* Varies according to the applied load, temperature, and cutoff voltage.
PRODUCT DATASHEET
1-800-383-7323 / USA
1-800-383-7323 / CANADA
1-800-383-7323 USA/CAN
www.energizer.com
Schedule: Continuous
Typical Drain @1.55V:
0.078 milliamperes
Load: 20K ohm
1.0
1.1
1.2
1.3
1.4
1.5
1.6
1.7
0 150 300 450 600 750
Service, Hours
Voltage, CCV
DESIGNED FOR USE ON CONTINUOUS LOW DRAIN
HIGH PULSE ON DEMAND
Service Effects
0
25
50
75
100
125
-20 0 20 40
Temperature (C)
Service (%)
Storage Effects
60
70
80
90
100
024681012
Storage Time (yrs)
Service (%)
40°C
20°C
0°C
Anode Cap
Gel Anode
Gasket
Can
Separator
Cathode
9.50 (0.374)
9.15 (0.360)
R0.70 (0.028) Ref.
Typical
3.80 (0.150)
Minimum
2.40 (0.094)
2.70 (0.106)
2.41 (0.095) Ref.
2.16 (0.085) Ref.
0.03 (0.001) Minimum Ref.
(applies to top edge of gasket or
edge of crimp, whichever is higher)
0.25 (0.010) Maximum Ref.
Permissible defelection from a flat
Form No. EBC - 4362A Page 1 of 1

Energizer 395 Specifications

General

Brand	Energizer
Model	395
Category	Camera Accessories
Language	English

Summary

Product Specifications

Chemical System

Specifies the battery's chemical composition as Silver Oxide (Zn/Ag2O).

Designation

Lists the industry designations for the battery, ANSI-1162SO/1165SO, IEC-SR57.

Nominal Voltage

States the standard operating voltage of the battery, which is 1.55 Volts.

Typical Capacity

Indicates the typical capacity of 52 mAh, tested to a cutoff voltage of 1.3 volts.

Capacity Test Conditions

Details the conditions for capacity testing: 20K ohm continuous drain at 21°C.

Typical Weight

Provides the typical weight of the battery as 0.8 grams (0.03 oz.).

Typical Volume

Specifies the typical volume of the battery as 0.19 cubic centimeters.

Impedance

States the typical impedance of the battery at 40 Hz, ranging from 5 to 15 ohms.

Industry Standard Dimensions

Cross Section Diagram

Performance Characteristics

Typical Discharge Characteristics

Graph and data showing voltage drop over service hours under continuous drain.

Service Effects by Temperature

Graph illustrating how service performance is affected by varying temperatures.

Storage Effects on Service

Graph showing service percentage retention based on storage time and temperature.