Energizer Connect EAC2-1002-RGB - Pairing Step 3: Bulb Installation; Install Bulb and Enter Pairing Mode; Pairing Mode Definitions

Blinking Definitions
EZ MODE Rapidly blinking (about 4 times per sec)
AP MODE Slowly blinking (about 2 times per sec)
Note: If your bulb is not rapidly blinking you
will need to reset it. See the troubleshooting
instructions on page 9 .
Turn off power to the light socket. Screw the bulb into
the light socket. Turn power back on.
3
The bulb should start blinking rapidly (about 4 times
per second) for EZ pairing mode.
3