Model no. EDC12035 / Contact us 1 866 295-6775
9
7
8
6
LED
Carry Handle
Pressure Setting Buttons
▲/ ▼
Thread Connection
LED Button
Hose Holder
Pre-set Button (for Auto
Shut-off)
Air Hose
12 Volt Plug
5
1
2
3
4
2
WARNING
WARNING
Please carefully read the manual included
with this product. Misuse of the unit could
cause property /equipment damage and/or
personal injury.
7
8
10
11
12
9
6
5
1
2
3
4
Do not overinflate products beyond
manufacture’s recommendations.
Do not allow the compressor or its
components to get wet.
Do not leave the air compressor
unattended while in operation.
Do not allow children to handle or operate
this compressor.
Do not use this product other than for its
intended use.
Do not disassemble or tamper with this
compressor.
Inspect air compressor before use. If
cracked, broken or damaged parts are
found, have them repaired or replaced
by a qualified technician.
IMPORTANT
1. The product records latest pre-set pressure. For example, if your pre-set pressure
gauge is 45 PSI, the product records the pre-set pressure at 45 PSI for the next time.
2. Before reaching desired pressure, the Compressor can shut off manually by
moving the On/Off switch to ‘I’ position.
OPERATION
This product is equipped with an Auto
Shut-Off Digital Pressure Gauge. The Digital
Gauge can be used to monitor air pressure
when inflating your desired objects, and can
automatically shut off once pre-set desired
pressure is reached.
Never expose the air compressor to rain,
frost or temperatures above 30
o
C (86 °F)
or temperatures below -30
o
C (-22 °F).
This compressor must be plugged into the
12v power outlet/socket in your vehicle only.
For best results it is recommended to have
your vehicle running.
Make sure the cord is not exposed to hot
objects, oil or sharp edges.
WARNING! For your own safety, you should
only use accessories and parts specified
in the instructions, or recommended for
use by the manufacturer.
To Next Page
Loading...