What to do if my EnergyLogic Boiler burner doesn't operate when there's a call for heat?
If the burner on your EnergyLogic Boiler doesn't operate when there is a call for heat, consider the following: Check the wall T-Stat, Boiler Controls, Low Fuel Cutoff (Check Continuity), Burner Plug, Primary Controller, and Preheater.
Why does my EnergyLogic Boiler burner run for 15-45 seconds then stop, requiring a primary control reset?
If your EnergyLogic Boiler burner runs for 15-45 seconds, then stops, and the red button of the primary control requires a reset, consider checking the Burner Motor, Primary Controller, Cad Cell, Tank/Tank Controls, Pump/Filter, Fuel Quality, Transformer/Electrode, and Air Compressor.
General| Heating Capacity | 200, 000 BTU/hr |
|---|---|
| Operating Pressure | 30 PSI max |
| Fuel Type | Natural Gas |
| Electrical | 120V, 60Hz |
| Chimney Size | 8 inches |
To Next Page