Enernova ETA - Operational Modes and Alarms

3.5 Power Alarm Function
3.5.1 The product power in close to the total battery capacity of about
6%, every 80 ~ 90 seconds cycle, each time a continuous reminder of 3
sounds, while the icon & flashes until the user to turn off the AC
output, or low power (about 5%) automatically turn off the AC output,
when the DC interface can be used normally.
3.5.2 When this product triggers the protection mechanism, it will au-
tomatically cut off all outputs and enter the alarm reminder, while the
alarm icon £ on the screen will flash synchronously and continue to
alarm for 60 seconds until the user manually turns off the power.
3.6 Charging and Discharging at the Same Time
This product supports charging and discharging at the same time, you
can use the output while charging. However, when the output power is
greater than the charging power, the battery power will slowly decrea-
se and will automatically shut down the output when it is reduced to
the protection voltage. When the output power is less than the char-
ging power, it will continue to charge the battery, but the charging time
will be extended.
3.7 Automatic Shutdown
3.7.1 Product with Load:
When the AC output port reaches the set protection power during
discharge, it will trigger the protection mechanism of the power supply
to shut down automatically.
3.7.2 In the state of no loading, the AC and DC ports will automatically
shut down after 80s and the device will shut down at the same time.
In the state of wireless charging mode on and no loading, the wireless
charging function will automatically shut down after 70s and the
device will automatically shut down after 80s of wireless charging func-
tion automatically shut down.
09