Enernova ETA - Page 13

3.7.3 With no loading and Standby-Mode on:
The device will stay on and will not automatically shut down even if
there is no output from all ports (the wireless charging function will still
automatically turn off for 70S with no load).
Under normal operating conditions, if the power of the equipment
brought exceeds the specified value, the power supply will protect and
shut down. You can use a slightly smaller power device to test, if it can
work normally, it means that the power of the current equipment with
the power supply exceeds the rated power.
The product is equipped with a variety of internal abnormal protection,
if there is no abnormal equipment with the power supply automatical-
ly shut down, please refer to the product troubleshooting to find or
return to repair.
3.8Fan
The internal fan of the product is an inverter fan, which is controlled by
temperature. When the temperature of the power supply exceeds 45°C
or more, the fan will start running and speed up as the temperature
rises in order to better help the power supply dissipate heat. Therefore,
itis normal for the fan to run suddenly during use (the icon a on the
display will rotate). In order to ensure the safe operation of the machi-
ne, the fan will increase the speed when the temperature is too high in
alimited space, so the fan running sound will also increase.
After stopping running the load, the product is still hot inside, so the
fan will continue to run and dissipate heat to extend the life of the
device. Generally, the fan will stop spinning after about 20 minutes of
operation (depending on the load power and temperature).
3.9 Wireless Charging
Wireless charging is marked on the top of the power supply (the circle
in the middle is the center of the wireless charging), turn on the wire-
less charging switch when using, wireless charging will be turned on.
10