Enernova ETA - Page 14

Please put the phone in the center, wait a few seconds for the power
supply and the phone docking agreement to start wireless charging, at
this time the phone will show the charging logo.
3.10 LED Light
Clicking the LED flashlight button will turn on the LED lighting, clicking
the button in turn will enter the normal mode, high brightness mode,
SOS mode. Long press the LED button in any mode will turn off the LED
lighting.
3.11 Reading Light
Click the reading light button to turn on the reading light lighting, with
four different brightness, long press the reading light switch in any
brightness mode, will turn off the reading light
3.12 Standby Supply Mode
ETA has a unique Standby-Mode designed for devices that require long
periods of low power operation (such as CPAP, inverter refrigerator,
etc.). When you press the Standby-Mode button, the device will not au-
tomatically shut down until the user manually shuts down or runs out
of power.
3.12 Temperature Unit Switching °C 2 °F
ETA can switch the unit of displaying operating temperature (°C and °F
switch with each other) in the following way.
Press the following buttons in order in the power off state 1.
(Short press)==>2. (E==E(Short press)==>3. (EIP (Short press)==>4.
@2 (Long press 3-4s), after that, you can turn on the power. If you
find that you have not successfully switched the temperature unit after
turning on the power, you can repeat the above operation again after
turning off the power.