Enernova ETA - Error Handling and Overheating

5.6 Wirelessly Charging Failure
5.6.1 Only when the Wireless Charge output switch is turned on can the
wireless charging function be used.
5.6.2 Wrong position:
Please move the phone to the corresponding position.
5.6.3 In order to wireless charging function properly, please do not use
more than 3-5mm thick phone case.
5.6.4 The surface is hot:
Because the coil of wireless charging is hot, so there will be a little heat
at the wireless charger. But please pay extra attention to the back of
the phone can not have metal substances, which will lead to abnormal
heating and can not be charged properly.
5.7 Product Overheating
When the power station with a larger load, the inverter at the top and
the battery at the bottom will generate a certain amount of heat, the
cooling fan will start to dissipate heat, even so, the shell will still have a
certain temperature rise, the temperature of the shell will reach about
40 degrees in the area where the heat is concentrated at full load (rela-
ted to the ambient temperature), this situation is normal.
5.8 DC and USB Output Error
5.8.1 Corresponding switch is not turned on:
Make sure the DC switch is pressed and the corresponding icons is lit.
5.8.2 Output overload protection:
When the DC and USB output is overloaded, the output will be auto-
matically cut off and the alarm icon will flash. At this time, you need to
disconnect the connected device with the power supply, and then
press the DC switch again and make sure the alarm icon is no longer
flashing to use again.