Enernova ETA - Page 5

6. In order to extend the cycle life of the battery, please charge and
discharge the product 1-2 times before store it for more than 6 months.
7. In order to preserve the power of the product, please turn off the
product in time after using so as to avoid running out of the battery
power (the device will have no-load loss as long as it is turned on).
8. When the product runs out of power, please charge it in time.
9. If the product emits abnormalities such as odor and overheat during
charging or storage, please stop charging immediately and place it in
an open place for observation from a distance to confirm safety, and
contact the manufacturer or distributor after it.
10. The product has a wireless charging function. If the wireless char-
ging switch is turned on, the wireless charging function will be turned
on. Please note that the charging part on the back of the phone cannot
be made of metal (such as a bracelet). If there is metal, it will cause
heat. Do not put metal objects or radio-sensitive items on the top of
the power supply. Otherwise, it may cause abnormal heat or even
damage!
11. This product is a power station, please select the corresponding
model according to the electrical equipment. The use of this product
with excessive power and load is prohibited.
12. When the short-circuit protection occurs after the product is con-
nected to the device, if it is still protected after restarting, please do not
restart it again. You should find the reason for the protection of the
connected device, and then continue to use the product after
troubleshooting.
13. This product is factory set according to the voltage standards of di-
fferent countries. Please consult the dealer or check the product instru-
ction manual before purchase and use.
14. The mesh holes on both sides of the power supply are heat dissipa-
tion holes, which are strictly prohibited to be blocked and a certain
space should be reserved to ensure the heat dissipation effect.