Need help?Do you have a question about the Eneroid EN10A3 and is the answer not in the manual?
Connect the C-Type cable and press the power button to enter standby mode.
Close the cover and press the power button to start charging; the red LED blinks.
Use charged batteries from the right compartment; discard defective ones from the left.
LED lights at the top of the ring when no battery or no charge is possible.
LED lights at the bottom of the ring when the compartment is full and ejects.
LEDs light up at the top of the ring for malfunctions or unknown problems. Contact service.
General| Brand | Eneroid |
|---|---|
| Model | EN10A3 |
| Category | Battery Charger |
| Language | English |
To Next Page