CHARGE
Plug it in to fully charge
from AC or solar panels.
Packing List For GENERATR S100
19V/30W Input Adaptor
Output Power Cord
User Manual
Dell Tip (M9)
HP Tip (M20)
IBM Tip (M11)
19V Output Tip (M12)
Included with the Generatr S100
are laptop charging tips that can be
used with the 19V output cable to
directly charge Dell, HP, and
ThinkPad laptops. Check with the
laptop manufacturer to ensure
the intended tip is compatible with
your laptop. These tips optimize the
charging process by removing
the conversion of current to 110V.
If the correct tip is not included,
the 110V AC output can be used
to charge laptops.
Warranty available at
goenerplex.com
POWER
Ensure your gear is compatible by
reviewing the specifications
on your device and the S100.
Plug in any USB, 12V, 19V or AC device.
RECHARGE
Recharge with EnerPlex
solar chargers or AC wall power.
M20 Tip for HP
M9 Tip for Dell
M12 Tip
M11 for Thinkpad
Technical Specifications
Usage:
Internal
General
Warranty information available at goenerplex.com
If you require assistance please contact us
support@goenerplex.com
Ascent Solar Technologies Inc.
12300 Grant St. Thornton, CO 80241
Outputs
Charging With: Approximate Charge Times
Battery Type Lithium-ion
Battery Capacity 94.0Wh (10.8V/8700 mAh)
Life-span More than 300 cycles
Weight 2.05lbs(930g)
Dimensions 6 X 6 X 1.9inch(152.5X 152.5 X 48.5mm)
Tested and Certified FCC, CE, RoHS
Operating Usage Temp. 14 - 122F (-10 - 50°C)
AC Wall Charger 5 hours
EnerPlex Commander XII
3~8 hours (2 pcs) depending on solar conditions
Charging Port (7.4 x 5.0 mm) 16~34V, 38W MAX
USB Port(Type –A) 5V, 2.4A MAX x 2
12V Port (6.3 x 3.0mm) 12V, 10A MAX
Laptop Port (7.4 x 5.0 mm) 19V, 90W MAX
AC 110V AC 100W RATED 120W MAX
We recommend that you leave your EnerPlex S100 plugged
in before use. If this is not possible, charge it every 3 months.
TM
6~16 hours (1 pcs) depending on solar conditions
OFF / 19V / 12V / AC
19V OUTPUT 12V OUTPUT
USB OUTPUTFour-mode Switch
INPUT
16-34V/38W MAX
110V-AC OUTLETLIGHT
Generatr S100
GENERATR S100
User Manual
MODEL:GN6001GY
FLIP
Flip the switch to the
appropriate mode and power
your devices.
3 4
1 2
ON Slide the Switch to 19V/12V/AC Position (Beeps 0.3 Seconds)
OFF Slide the Switch to OFF Position (Beeps Twice)
Charging Plug-in Power (Beeps 0.3 Seconds)
LED Sequential Charging
All LED On Charging Completed
All LED Fast Blinking Overloading, UNPLUG OUTPUTS
LED Blinking Battery Remaining Display
Last LED Fast Blinking Low Battery (Beeps 3 Seconds)
Light and Beep Indicators
To Next Page
Need help?
General