To Next PageTo Next Page
Need help?Do you have a question about the Enertronica Santerno SINUS PENTA and is the answer not in the manual?
General| Model | SINUS PENTA |
|---|---|
| Manufacturer | Enertronica Santerno |
| Maximum Input Voltage | 1000 V |
| MPPT Voltage Range | 200 V - 800 V |
| Nominal Output Voltage | 400 V |
| Protection Degree | IP65 |
| Operating Temperature Range | -25°C to +60°C |
| Output Frequency | 50Hz/60Hz |
Guidance on the installation and operation of the SU465 power supply unit.
Detailed electrical and mechanical specifications for the SU465 unit.
Comprehensive installation procedures for the SU465 unit.
Layout and identification of power and signal terminals on the SU465.
Detailed instructions for connecting control signals via DB9 connectors.
Guidelines for selecting braking resistors for drives with internal braking units.
Details on the BU200 braking unit's operation, configuration, and installation.
Information on BU600 braking units for parallel drive configurations.
Specifications and dimensions for various available braking resistor models.
Instructions for remotely mounting the keypad on the cabinet.
Details on input inductors and their benefits in reducing harmonic currents.
Information on output inductors (DU/DT filters) for reducing voltage stress.
Guidelines for selecting and applying inductors to the inverter.
Information on sine filters and their benefits in enhancing equipment performance.
Details on output toroidal filters used to weaken cable disturbance.
Detailed electrical specifications for the ES836/2 encoder board.
Step-by-step guide for installing the ES836/2 encoder board into Slot A.
Instructions for configuring DIP-switches on the ES836/2 encoder board.
Procedure for adjusting the encoder supply voltage trimmer on ES836/2.
Electrical specifications for the ES913 Line Driver Encoder Board.
Step-by-step guide for installing the ES913 Line Driver Encoder Board.
Instructions for configuring DIP-switches on the ES913 encoder board.
Step-by-step guide for installing the ES860 Sin/Cos Encoder Board into Slot A.
