eNet GIRA User Manual

eNet Server
eNet Server
Order no.: 5301 00
Operating instructions
1 Safety instructions
Electrical devices may only be mounted and connected by electrically skilled persons.
Serious injuries, fire or property damage possible. Please read and follow manual fully.
Fire hazard! Operation exclusively with the power supplies listed under accessories
The radio communication takes place via a non-exclusively available transmission path, and is
therefore not suitable for safety-related applications, such as emergency stop and emergency
call.
These instructions are an integral part of the product, and must remain with the end customer.
2 Device components
Figure1: Front view eNet server
(1) Slide for retaining the antenna cable
(2) Buttons for manual operation and restart
(3) LEDs
(4) Voltage supply connection
(5) Data cable connection
(6) Socket for external eNet antenna
(7) RJ45 socket for Ethernet connection
(8) Socket for external WLAN antenna
3 Function
Intended use
– Commissioning, diagnosis and maintenance of an eNet installation via PC, tablet and
laptop
– Operation of an eNet installation via smartphone
– Radio receiver for eNet RMD modules
– Operation only with approved voltage supply (see accessories)
1 / 7
32580552 10864944 01.02.2022

eNet GIRA Specifications

General

Brand	eNet
Model	GIRA
Category	Server
Language	English

Summary

Safety Instructions

Device Components Overview

Voltage Supply Connection

Data Cable Connection

External eNet Antenna Socket

RJ45 Ethernet Socket

External WLAN Antenna Socket

Function and Intended Use

Intended Use

Commissioning, diagnosis, maintenance via PC/tablet/laptop; operation via smartphone; radio receiver for RMD modules; use with approved voltage supply.

Device Operation

Device Control Buttons

Performing a Restart

Resetting Network Configuration

Resetting Users and Passwords

Delete Project

Installation and Connection

Mounting and Electrical Connection

Safety warnings for electrical work, and instructions for connecting external antennas.

Fitting the Device

Connecting the Device

Diagram and instructions for connecting the device, including bus line and power supply.

Connection Assignment

Table detailing the labelling, colour, and connection type for power and data cables.

Commissioning the eNet Server

Connecting Computer with eNet Server

Steps for connecting a computer to the eNet Server via wired LAN for initial setup.

Connection via IP Address

Procedure to access the eNet Server's commissioning interface using its IP address.

Connection via Domain Name

Procedure to access the eNet Server's commissioning interface using its domain name.

Logging into Commissioning Interface

Instructions for entering username and password to access the commissioning interface.