Engcon SS9-2 - Operating the Quick Hitch Lock; Program Selection

4 Operation
4.2. Operating the quick hitch lock
For further information on bucket connection/disconnection, see
the tiltrotator user manual.
For tiltrotators with SS9 SQ, see the base machine's user manual.
For tiltrotators with SS9 IQ, see section 4.1. Manoeuvring
4.3. Program selection
This section describes how to change program selections.
1
ec1
Hold down ec1 when powering up the machine,
wait for the buzzer to stop and then beep twice.
2
ec1
X2
Press ec1 twice
3
ec1
The buzzer will beep every time the program is
changed
4
ec1
3
seconds
To save program selection:
Hold down ec1 until the buzzer beeps twice.
Description of monostable and bistable modes:
Monostable refers to a button that reverts to its previous function when released. Bistable
refers to a button that remains in position when released until another button is depressed.
Program 1
Tilt and Extra 1+2 are switched bistably with button 1.
Both extra outputs are always run in parallel.
Program 2
Extra 1-2 are switched in monostably when the operator
presses and holds down button 1.
Program 3
Three buttons are used for bistable switching between
Tilt, Extra1 and Extra2.
Program 4
Two buttons are used for monostable switching between
Tilt and Extra1, and between Tilt and Extra2.
17