After selecting the time display mode, the sensor unit will update to the
correct degree reading automatically: Now the hour digits is flashing, press +
key briefly to increment hour, if + key is pressed longer than 2 seconds, then
hour digit will be incremented automatically in 4HZ speed. Press SET key
to confirm and now the minute digits will be flashing. Press + key to set
minute accordingly. Press SET key to confirm the entered time. Seconds will
be cleared to 0 internally for synchronization.
2. Check Min/Max record
Press MIN/MAX key (shared with SET key) in normal mode, the MIN icon
and minimum indoor and outdoor channel temperature record will be
displayed. Press MIN/MAX key again, the MAX logo and Max record will be
displayed. Press MIN/MAX key the third time, MAX logo disappear and go
back to normal display mode.
3. Reset Min/Max record
Press RESET key(shared with + key) during normal display mode for 2
seconds, Min/Max record will be reset to current temperature.
** If key is pressed for longer than 30 seconds, the unit will switch itself
to normal display mode automatically.
Specification
•
Ambient (receiver unit) temperature range: 0 to +60
•
Fridge (remote sensor) temperature range: -40 to +65
•
Temperature accuracy: +/-1.0
•
Power requirement(receiver): 2xAA LR6 alkaline batteries
•
Power requirement(transmitter): 2XAAA LR03 alkaline batteries
•
Battery life: Approximately 24 months for receiver.
Approximately 24 months for transmitter.
•
Transmission frequency: 433MHZ
•
Transmission range: 300 feet (100 meter) in open area
Caution
•
Do not reverse polarity of the batteries
•
Do not put receiver close to metal
How to fix remote
sensor
Note:
1. Use Adhesive Hook and Loop
provided
for both the Receiver unit and
the
Remote sensor
unit.
3. Dispose of waste batteries
correctly
.
4. The warranty of this
product
won't be honored if damage is caused
by
negligence, improper
use and or
tampering.
To Previous Page
Loading...